GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Uplander Ext. 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Automatic Level Control Sensor Link Replacement

Removal Procedure
  1. Remove the ELC/TRAILER fuse.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

    3. Object Number: 380438 Size: SH

    Note: When removing the link, do NOT bend or break the sensor arm.

  3. Remove the automatic level control sensor link from the tie rod ball stud.
  4. Remove the ball stud from the rear axle tie rod.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 380438 Size: SH
  1. Install the ball stud to the rear axle tie rod and tighten to 12 N·m (106 lb in) .
  2. Install the automatic level control sensor link to the tie rod ball stud.
  3. Lower the vehicle.
  4. Install the ELC/TRAILER fuse.