Removal Procedure
- Reposition the underhood electrical center. Refer to
Underhood Electrical Center or Junction Block Replacement .
- Remove the right front diagonal brace. Refer to
Front End Sheet Metal Diagonal Brace Replacement .
- Disconnect the electrical connectors from the washer pumps.
- Disconnect the washer hose connections at the front and rear washer pumps.
- Contain the washer solvent in a suitable container.
- Disconnect the 2 front engine wiring harness connections from the wiring harness.
- Remove the bolts from the fender flange and inner wheelhouse.
- Lower the washer container into the engine compartment.
- Carefully pull the forward engine harness over the top of the washer container spout.
- Remove the washer solvent container (2) from the engine compartment.
- Transfer the following components:
| • | Rear washer pump, if equipped |
Installation Procedure
- Install new grommets into the washer container for the wiper washer pumps.
- Install the following removed components:
| • | Rear washer pump, if equipped |
- Pull the engine harness forward and lower the container into the engine compartment.
- Position the underhood electrical harness over the top of the washer container spout.
- Position the washer container (2) to the right front inner fender.
Caution: Refer to Fastener Caution in the Preface section.
- Install the bolts and tighten in sequence, as shown, to
6 N·m (53 lb in)
.
- Connect the washer jumper hoses.
- Connect the electrical connectors.
- Install the right front diagonal brace. Refer to
Front End Sheet Metal Diagonal Brace Replacement .
- Reposition the underhood electrical center. Refer to
Underhood Electrical Center or Junction Block Replacement .
- Refill the washer container with new washer solvent.
- Verify the operation of the wipers/washer systems.
