Warning: Refer to Battery Disconnect Warning in the Preface section.

1. Record all presets and theft codes from the radio.
2. Turn off all the lamps and accessories.
3. Turn the ignition OFF.
4. Loosen the negative battery cable (2) nut.
5. Remove the negative battery cable from the battery.

Note: Clean any existing corrosion from the battery terminal bolt and the battery cable.

1. Install the negative battery cable to the battery.

Caution: Refer to Fastener Caution in the Preface section.

2. Tighten the negative battery cable (2) nut and tighten to 16 N·m (12 lb ft) .
3. Reprogram the radio presets. Refer to Radio Programming and Setup .
4. Re-initialize the power sliding doors. Refer to Rear Side Door Actuator Control Module Programming and Setup .