For 1990-2009 cars only
Removal Procedure
- Open the side doors.
- Partially remove the weatherstrip from the roof drip rail, by pulling it from the flange.
- Remove the weld joint molding from the roof studs using a flat-bladed tool.
- Remove the weld joint molding from the roof.
- Remove the insulators from the weld joint molding, if necessary.
- Remove the weld joint molding retainers from the weld joint molding using a flat-bladed tool, if necessary.
Notice: Refer to Exterior Trim Emblem Removal Notice in the Preface section.
Installation Procedure
- Install the weld joint molding retainers to the weld joint molding, pressing until fully seated.
- Install the insulators to the weld joint molding, if removed.
- Position the weld joint molding to the roof.
- Press the weld joint molding onto the roof studs, until fully seated.
- Install the weatherstrip to the roof drip rail.
- Press the weatherstrip onto the flange until fully seated.
- Close the side doors.
