The electronic brake control module (EBCM) monitors the voltage level available for system operation. If the voltage level is too high, damage may result to the system. When the EBCM detects a high voltage condition, the EBCM disables the ABS system.
This diagnostic procedure supports the following DTC:
DTC C0900 Device Voltage High
The vehicle speed is greater than 8 km/h (5 mph).
The system voltage is greater than 17 volts.
If equipped, the following actions will occur:
• | The EBCM disables the ABS . |
• | Dynamic rear proportioning (DRP) is degraded when the code is current. |
• | The EBCM disables the traction control system (TCS). |
• | The EBCM disables vehicle stability enhancement system (VSES). |
• | The ABS indicator turns ON. |
• | The driver information center (DIC) displays the Service Stability System message. |
• | The DIC displays the Service Traction System message. |
• | The condition for the DTC is no longer present and the DTC is cleared with a scan tool. |
• | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
A possible cause of this DTC is overcharging.
The numbers below refer to the step numbers on the diagnostic table.
Use the scan tool in order to inspect the voltage to the EBCM.
Use the scan tool in order to inspect the voltage to the body control module (BCM). A high voltage value in multiple modules indicates a concern in the charging system.
This step verifies that the condition is still present.
Step | Action | Values | Yes | No |
---|---|---|---|---|
Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Antilock Brake System Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
Does the scan tool indicate that the voltage is greater than the specified value? | 17 V | Go to Step 3 | Go to Diagnostic Aids | |
With a scan tool, observe the Battery Volts parameter in Body Control Module (BCM) data list. Does the scan tool indicate the voltage is greater than the specified value? | 17 V | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information | Go to Step 4 | |
Does the DTC reset? | -- | Go to Step 5 | Go to Diagnostic Aids | |
5 | Replace the electronic brake control module (EBCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the repair? | -- | Go to Step 6 | -- |
6 |
Does the DTC reset? | -- | Go to Step 2 | System OK |