Removal Procedure
- Remove the blower motor. Refer to
Blower Motor Replacement
.
- Disconnect the electrical connector from the blower motor resistor.
Important: Loosen the rearward blower motor resistor screws. The rearward blower motor resistor holes are slotted.
- Loosen the rearward blower motor resistor screws (3).
- Remove the forward blower motor resistor screw (3).
- Remove the blower motor resistor (4).
Installation Procedure
- Install the blower motor resistor (4).
- Install and snug the forward blower motor resistor screw.
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the rearward blower motor resistor screws (3).
Tighten
Tighten the screws to 1.2 N·m (11 lb in).
- Connect the electrical connector to the blower motor resistor.
- Install the blower motor. Refer to
Blower Motor Replacement
.