Front wheel drive axles are flexible assemblies.
Front wheel drive axles consist of the following components:
| • | A front wheel drive shaft tripot joint (inner joint) |
| • | A front wheel drive shaft constant velocity joint (outer joint) |
| • | A front wheel drive shaft |
| | The front wheel drive shaft connects the front wheel drive shaft tripot
joint and the front wheel drive shaft constant velocity joint. |
The front wheel drive shaft tripot joint is completely flexible. The
front wheel drive shaft tripot joint can move in and out.
The front wheel drive shaft constant velocity joint is flexible, but
the front wheel drive shaft constant velocity joint cannot move in and out.
Boots (Seals) And Clamps
The front wheel drive shaft constant velocity joint and the front wheel
drive shaft tripot joint boots (seals) in the front wheel drive axle are
made of a thermoplastic material.
The clamps in front wheel drive axle are made of stainless steel.
The boot (seal) provides the following functions:
| • | Protection of the internal parts of the front wheel drive shaft
constant velocity joint and the front wheel drive shaft tripot joint. |
| | The boot (seal) protects the grease from the following sources of damage: |
| - | Harmful atmospheric conditions (such as extreme temperatures or
ozone gas) |
| - | Foreign material (such as dirt or water) |
| • | Allows angular movement and the axial movement of the front wheel
drive shaft tripot joint. |
| • | Allows angular movement of the front wheel drive shaft constant
velocity joint. |
Important: Protect the boots (seals) from sharp tools and from the sharp edges
of the surrounding components.
Any damage to the boots (seals) or the clamps will result in leakage.
Leakage will allow water to leak into the front wheel drive shaft tripot joint
and the front wheel drive shaft constant velocity joints. Leakage will also
allow grease to leak out of the front wheel drive shaft tripot joints and
the front wheel drive shaft constant velocity joints.
Leakage may cause noisy front wheel drive axle operation and eventual
failure of the internal components.
The clamps provide a leak proof connection for the front wheel drive
shaft tripot joint and the front wheel drive shaft constant velocity joint
at the following locations:
| • | The front wheel drive shaft |
The thermoplastic material performs well under normal conditions and
normal operation. However, the material is not strong enough to withstand
the following conditions:
| • | Damage from sharp objects (such as sharp tools or any sharp edges
of the surrounding components in the vehicle). |
Front Wheel Drive Shaft Tri-pot Joint (Inner Joint)
The front wheel drive shaft tripot joint is made with the tripot design
without an over-extension limitation retainer.
The joint is constructed as follows for vehicles that are equipped with
an automatic transmission:
| • | The left front wheel drive axle has a female spline. The female
spline installs over a stub shaft that protrudes from the transaxle. |
| • | The right front wheel drive axle has a male spline. The right
front wheel drive axle uses barrel type snap rings in order to interlock with
the transaxle gears. |
Front Wheel Drive Shaft Constant Velocity Joint (Outer Joint)
The front wheel drive shaft constant velocity joint is made with the
Rzeppa joint design.
The shaft end (which mates with the knuckle/hub) has a helical spline.
The helical spline ensures a tight, press-type fit.
This design prevents end play between the hub bearing and the front
wheel drive axle.
