GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Venture Ext. 🢒 Engine 🢒 Engine Electrical 🢒 Engine Support Fixture

Tools Required

    • J 28467-B Universal Engine Support Fixture
    • J 28467-6A Bracket Assembly
    • J 28467-7A Bolt Hook
    • J 28467-8A Hook Assembly
    • J 28467-34 Lift Hook Wing Nut and Washer
    • J 28467-500 Engine Support Fixture
    • J 28467-500UPD Utility Straps

Installation Procedure
  1. Remove the right side engine mount strut. Refer to Engine Mount Strut Replacement - Left Side or Engine Mount Strut Replacement - Right Side .

    2. Object Number: 105924 Size: SH
  2. Install the J 28467-500 .

    3. Object Number: 105927 Size: SH
  3. Install the spreader bar to the engine mount strut bracket.

    4. Object Number: 105928 Size: SH
  4. Install the spreader bar to the engine right side engine lift hook.
  5. Install the J 28467-6A .

    6. Object Number: 105925 Size: SH
  6. Install the J 28467-7A to the engine left side engine lift hook.
  7. Install the J 28467-34 .
  8. Install the J 28467-6A .

    9. Object Number: 105926 Size: SH
  9. Install the J 28467-8A to the spreader bar.
  10. Install the J 28467-34 .

    11. Object Number: 105923 Size: SH
  11. The engine support fixture upper portion installed.

    12. Important: Perform the following steps only if you are disconnecting both of the powertrain mounts from the frame or the powertrain.

  12. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    13. Object Number: 490977 Size: SH

    Caution: The utility straps MUST be installed in order to prevent forward movement of the powertrain. If the utility straps are not installed, the powertrain will move which may cause personal injury and vehicle damage.

  13. Install the J 28467-500UPD to the engine.

    14. Object Number: 521400 Size: SH
  14. Install the J 28467-500UPD opposite end to the underbody rail.

    15. Object Number: 490980 Size: SH
  15. Install the OTHER J 28467-500UPD to the transaxle.

    16. Object Number: 521392 Size: SH
  16. Install the J 28467-500UPD opposite end to the underbody rail.
  17. Tighten both of the J 28467-500UPD utility straps in order to prevent forward movement of the powertrain.

Removal Procedure
  1. Remove both of the J 28467-500UPD .
  2. Lower the vehicle.
  3. Remove the J 28467-34 .
  4. Remove the J 28467-7A .
  5. Remove the J 28467-6A .
  6. Remove the J 28467-34 .
  7. Remove the J 28467-8A .
  8. Remove the J 28467-6A .
  9. Remove the J 28467-500 .
  10. Install the right side engine mount strut. Refer to Engine Mount Strut Replacement - Left Side or Engine Mount Strut Replacement - Right Side .