GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Venture Ext. 🢒 Engine 🢒 Engine Cooling 🢒 Accelerator Control Cable Bracket Replacement

Removal Procedure

    Object Number: 12831 Size: SH
  1. Disconnect the accelerator cable cross slug from the throttle body lever.
  2. Disconnect the accelerator cable from the accelerator cable bracket.

    3. Object Number: 319387 Size: SH
  3. Disconnect the cruise control cable from the throttle lever and accelerator bracket, if applicable.
  4. Disconnect the air intake duct from the throttle body. Refer to Air Cleaner Inlet Duct Replacement .
  5. Disconnect the wire harness from the retainer.

    6. Object Number: 260171 Size: SH
  6. Remove the nut (3) and bolts (1, 2) holding the accelerator cable bracket to the throttle body.
  7. Remove the accelerator cable bracket.

Installation Procedure

    Object Number: 260171 Size: SH
  1. Position the accelerator cable bracket on the throttle body.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the nut (3) and bolts (1, 2).

    3. Tighten

        • Tighten the bolts in sequence (2, 1) to 13 N·m (115 lb in).
        • Tighten the nut in sequence (3) to 10 N·m (89 lb in).
  3. Install the wire harness into the retainer.
  4. Install the air intake duct. Refer to Air Cleaner Inlet Duct Replacement .