GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Venture Ext. 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Link Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    2. Object Number: 629209 Size: SH
  2. Use a wrench in order to hold the stabilizer shaft link. Remove the stabilizer shaft link nuts.
  3. Remove the stabilizer shaft link.

Installation Procedure

    Object Number: 629209 Size: SH
  1. Install the stabilizer shaft link.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the stabilizer shaft link nuts.

    3. Tighten
    Tighten the stabilizer shaft link nuts to 85 N·m (63 lb ft).

  3. Lower the vehicle.