Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .
2. Remove the condenser. Refer to Condenser Replacement .



3. Remove the receiver dehydrator upper mounting bolts.
4. Remove the receiver dehydrator lower mounting bolts.
5. Remove the receiver dehydrator.
6. Remove and discard the sealing washers.

1. If replacing the receiver dehydrator add the specified amount of PAG oil directly to the receiver dehydrator. Refer to Refrigerant System Capacities .
2. Using a lint-free clean, dry cloth, carefully clean the sealing surfaces of the A/C refrigerant line and the A/C refrigerant component.

Important: Flat washer type seals do not require lubrication.

3. Install new sealing washers for the receiver dehydrator.



4. Install the receiver dehydrator to the condenser.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the receiver dehydrator lower mounting bolts.

Tighten
Tighten the nuts to 6 N·m (53 lb in).

6. Install the receiver dehydrator upper mounting bolts.

Tighten
Tighten the bolts to 6 N·m (53 lb in).

7. Install the condenser. Refer to Condenser Replacement .
8. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
9. Leak test the fittings of the component using J 39400-A .