Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the inflatable
restraint steering wheel module. Refer to
Disabling the SIR System
in SIR.
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers - Disassemble - Off Vehicle
.
- Remove the 3 wire harness straps (3) from the wire
harness assembly (4).
- Remove the wire harness strap (2) from the upper tilt head
assembly (1).
- Pop the wire harness assembly (4) out of the wire harness
strap (5).
- Remove the 2 pan
head tapping screws from the turn signal and multifunction switch assembly.
Remove the turn signal and multifunction switch assembly.
- If necessary, disconnect the turn signal and multifunction switch
assembly connector (s).