Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the inflatable
restraint steering wheel module. Refer to
Disabling the SIR System
in SIR.
- Remove the steering column from the vehicle. Refer to
Steering Wheel Replacement
.
- Remove the steering column tilt head housing. Refer to
Steering Column Tilt Head Housing - Disassemble - Off Vehicle
.
- Remove the ignition and key alarm switch assembly. Refer to
Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle
.
- Disconnect the park lock cable assembly (1).
The lock cylinder should be in the OFF-LOCK position.
- Insert a small screwdriver into the slot on the electronic lock
module assembly and push against the locking tab to remove.
- Remove the 3 pan
head tapping screws (2) from the electronic lock module assembly (1).
- Remove the electronic lock module assembly (1).