Diagnostic System Check - Power Seat Systems Memory Seat
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
-
Determine if any DTCs are present which may be the cause of the condition.
-
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
-
Determine if an internal memory malfunction exists.
-
Determine if the ignition voltage monitored by the powertrain control module is within acceptable limits.
Step | Action | Yes | No | ||||||
|---|---|---|---|---|---|---|---|---|---|
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications | ||||||
Does the scan tool communicate with these systems? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |||||||
Select the display DTCs function for the following modules.
Does the scan tool display any DTCs? | Go to Step 4 | Go to Symptoms - Seats | |||||||
Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 5 | |||||||
Does the scan tool display DTC B1000? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Step 6 | |||||||
Does the scan tool display DTC P0560? | Go to Diagnostic Trouble Code (DTC) List in Engine Electrical |
