GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 561883  Size: SH

    Important: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.

    If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Refer to Rear Wheel Bearing and Hub Replacement in Rear Suspension.

  1. Raise and support the vehicle on a suitable hoist. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the rear wheel speed sensor electrical connector located next to the rear strut.

  4. Object Number: 230412  Size: SH
  5. Remove the hub and bearing assembly (1). Refer to Rear Wheel Bearing and Hub Replacement in Rear Suspension.

Installation Procedure


    Object Number: 230412  Size: SH
  1. Install the hub and bearing assembly (1) to the vehicle. Refer to Rear Wheel Bearing and Hub Replacement in Rear Suspension.

  2. Object Number: 561883  Size: SH
  3. Install the rear wheel speed sensor electrical connector.
  4. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
  6. Turn the ignition switch to the RUN position with the engine off.
  7. Perform Diagnostic system check. Refer to Diagnostic System Check - ABS .