Removal Procedure
Important: The RAP fuse MUST be removed 10 minutes before this procedure to avoid
damaging the new DVD player
- Remove the RAP fuse.
- Remove the bezel from the floor console. Refer to
Floor Console Accessory Power Receptacle Replacement
.
- Remove
the mounting screws from the DVD Player.
- Slide
the DVD player forward, and disconnect the electrical connectors from the DVD player.
Installation Procedure
- Connect
the electrical connectors to the DVD player.
Notice: Refer to Fastener Notice in the Preface section.
- Slide the DVD player inward and fasten with screws.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Install the bezel to the floor console. Refer to
Floor Console Accessory Power Receptacle Replacement
.
- Install the RAP fuse.
- Test the DVD player for proper operation.