Removal Procedure
- Remove the left side instrument panel insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gages
and Console.
- Rotate the cruise control release switch counterclockwise until the travel
stop has been reached (approximately 60 degrees).
Remove the cruise control release switch from the retainer.
- Disconnect the cruise control release switch electrical connector.
Installation Procedure
- Install the cruise control release switch electrical connector.
With the electrical connector index notch at the 10 o'clock position, install
the cruise control release switch to the retainer.
Important: Do NOT move or push the brake pedal.
- Slide the switch into the retainer until the plunger is fully depressed into
the barrel.
- Rotate the cruise control release switch clockwise until the travel stop has
been reached (approximately 60 degrees). The electrical connector index notch should
now be at the 12 o'clock position.
- Ensure that the cruise control system operates properly.
- Install the left side instrument panel insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument
Panel, Gages and Console.