Tools Required

J 38778 Door Trim Pad Clip Remover

1. Open the fuel filler door.
2. Remove the fuel cap.
3. Using J 38778 remove the push in retainer securing the fuel filler pocket to the left rear inner fender liner.
4. Remove the screws from the fuel filler pocket.
5. Remove the fuel filler pocket from the vehicle.
6. Depress tabs on the fuel cap tether and remove from the fuel filler pocket.

1. Align the fuel filler pocket to the vehicle

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screws to the fuel filler pocket.

Tighten
Tighten the screws to 10 N·m (89 lb in).

3. Install the push in retainer to the fuel filler pocket.
4. Install the fuel cap to the fuel filler pocket.
5. Close the fuel filler door.