Circuit Description
The instrument panel cluster (IPC) contains a momentary switch that controls the trip odometer reset and trip season display options. The IPC monitors the circuit voltage levels and detects when the trip odometer reset switch has been depressed.
DTC Descriptor
This diagnostic procedure supports the following DTCs:
| • | DTC B2823 Trip Odometer Reset Circuit Low |
| • | DTC B3574 Trip Odometer A or B (Trip Odometer 1 or 2) Select Switch Circuit Low |
Conditions for Running the DTC
The IPC must have normal operating battery voltage.
Conditions for Setting the DTC
The IPC detects that the trip reset switch input is low (grounded) for greater than 60 seconds.
Action Taken When the DTC Sets
The IPC will disable (ignore) the trip reset switch.
Conditions for Clearing the DTC
| • | A current DTC B2823 will clear after a complete ignition cycle. |
| • | A scan tool may be used to clear the DTC. |
Diagnostic Aids
| • | The IPC will store the code as current only as long as the failure exists. An intermittent failure will be stored as a history DTC B2823. |
| • | If DTC B2823 is set only in history, press and release the trip reset switch several times in order to verify the customer concern. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Instrument Cluster Schematics | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 |
Does the scan tool display Inactive? | Go to Step 3 | Go to Step 4 |
3 |
Does the Trip Reset Switch parameter change state and the odometer change from season to trip? | Go to Diagnostic Aids | Go to Step 4 |
4 | Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 2 | System OK |
