Circuit Description
The mobility seat module uses inputs from 4 limit switches in order to determine the seat position. The limit switch signal circuits are referenced from battery voltage within the module. The limit switches will open or close the switch signal circuits to ground in order for the module to determine them to be active or inactive. The swivel out limit switch signal circuit is considered to be active when the circuit reference voltage is low or closed to ground by the switch.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC 032 Swivel Out Limit Switch Remains Active After Start Rotation In
Conditions for Running the DTC
| • | Battery voltage must be within 9-16 volts. |
| • | Seat rotation in operation is attempted from the outward facing position. |
Conditions for Setting the DTC
After rotation inward operation has been in progress for 1 second from the outward facing position, the swivel out limit switch signal to the module remains low or active.
Action Taken When the DTC Sets
While the fault is current, the module will allow the seat to be rotated to the forward facing position and not allow outward rotation.
Conditions for Clearing the DTC
The DTC may be cleared by removing the main power supply or ground from the seat module.
Diagnostic Aids
Inspect the limit switch for any physical damage or obstructions to its mechanical operation which may cause the condition.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Power Seats Schematics | |||
1 | Did you review the description and operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Seats |
2 | Verify the fault is present. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the seat rotate to the swivel out hard stop? | Go to Step 6 | Go to Step 4 |
4 | Test the swivel out limit switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 7 | Go to Step 5 |
5 | Replace the mobility seat control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Is the repair complete? | Go to Step 7 | -- |
6 | Replace the mobility seat base unit. Refer to Sit-N-Lift Seat Base Replacement . Is the repair complete? | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
