Water in Jack Compartment (Reinstall Grommet)

Some customers may comment that there is water in the jack compartment.

This condition may be due to the power sliding side door grommet not being properly seated.

1. Open the lift gate.



2. Remove the RH seat belt cover by pushing down to release the top tab.



3. Place a 12 inch extension on the plastic housing keeping it as far rearward as possible. Refer to the illustration above for the proper placement.



4. This illustration shows the wrong placement of the extension.
5. With a 12 inch extension kept rearward for maximum forward motion, strike the extension with a hammer until the grommet is seated.
6. Verify grommet is seated properly by doing a water test.
7. Reinstall the seat belt cover.

For vehicles repaired under warranty, use: