GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Venture - 4WD 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Memory Seat Control Module Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling.
  2. Remove the seat.

    3. Object Number: 740755 Size: SH
  3. Disconnect the electrical connectors.
  4. Using a flat-bladed tool, gently pry the memory seat control module from the bracket slots.

    5. Object Number: 740757 Size: SH
  5. Slide the module toward the rear of the seat.

Installation Procedure

    Object Number: 740757 Size: SH
  1. Slide the module into the mounting bracket and push until the module is fully seated.

    2. Object Number: 740755 Size: SH
  2. Connect the electrical connectors.
  3. Install the drivers seat.
  4. Enable the SIR system. Refer to SIR Disabling and Enabling.
  5. Calibrate the seat. Refer to Control Module References for programming and setup information.