Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Sliding Door Schematics Connector End View Reference: Power Door Systems Connector End Views DEFINITION: The power sliding door alarm is inoperative or always on. The power sliding open/close functions operate normal. | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Turn the power sliding door ON/OFF switch to the ON position. Does the power sliding door alarm sound continuously? | Go to Step 5 | Go to Step 3 |
3 |
Does the power sliding door alarm sound continuously? | Go to Step 6 | Go to Step 4 |
4 |
Does the test lamp illuminate? | Go to Step 8 | Go to Step 7 |
5 | Test the power sliding door alarm control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 11 |
6 | Test the power sliding door alarm control circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 10 |
7 | Test the power sliding door alarm 12-volt supply circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 10 |
8 | Inspect for poor connections at the power sliding door alarm. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 9 |
9 | Replace the power sliding door alarm. Refer to Door Open Alarm Replacement . Is the repair complete? | Go to Step 12 | -- |
10 | Inspect for poor connections at the rear side door actuator control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 11 |
11 | Replace the rear side door actuator control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Is the repair complete? | Go to Step 12 | -- |
12 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
