GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Venture - 4WD 🢒 Restraints 🢒 SIR 🢒 DTC 014

Circuit Description

The rear side door actuator control module supplies the power and ground to operate the power sliding door actuator motor and the actuator clutch. The direction of the actuator motor rotation is determined by which of the control circuits is supplied 12 volts and which is grounded. The rear side door actuator control module varies the current flow through the actuator motor ground circuit to control the speed of the actuator motor as necessary. The actuator clutch enables the power sliding door to be operated manually when de-energized, or by the actuator motor when energized.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC 014 Actuator Motor Control Circuit Fault

Conditions for Running the DTC

A power sliding door open or close function is attempted.

Conditions for Setting the DTC

An actuator motor control circuit fault is detected by the rear side door actuator control module.

Action Taken When the DTC Sets
    • The rear side door actuator control module will attempt to operate the door and stop if the condition is current.
    • The rear side door actuator control module sets a DTC 014.

Conditions for Clearing the DTC

All stored DTCs are cleared whenever the on-board diagnostic modes are exited.

Diagnostic Aids
    • Inspect the power sliding door actuator motor pigtail harness and connector terminals for damage.
    • Inspect the actuator clutch pigtail harness and connector terminals for damage.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. Tests the rear side door actuator control modules ability to provide power and ground to operate the power sliding door actuator motor.

    2.

  2. Tests the rear side door actuator control modules ability to provide power and ground to energize the power sliding door actuator clutch.

Step

Action

Yes

No

Schematic Reference: Sliding Door Schematics

Connector End View Reference: Power Door Systems Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Disconnect the actuator motor connector to the rear side door actuator control module.
  2. Connect a test lamp across the actuator motor control circuit terminals from the rear side door actuator control module.
  3. Turn the power sliding door ON/OFF switch OFF to exit the on-board diagnostic modes.
  4. Manually close the power sliding door.
  5. Turn the power sliding door ON/OFF switch ON.
  6. Press the power sliding door OPEN/CLOSE switch.

Does the test lamp flash?

Go to Step 3

Go to Step 6

3

  1. Disconnect the actuator clutch and door alarm connector to the rear side door actuator control module.
  2. Connect a test lamp across the actuator clutch high and low control circuit terminals from the rear side door actuator control module.
  3. Press the power sliding door OPEN/CLOSE switch.

Does the test lamp flash?

Go to Step 4

Go to Step 6

4

Inspect and if possible repair any damage to the actuator motor or actuator clutch pigtail harnesses or connectors. Refer to Wiring Repairs and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 5

5

Replace the actuator motor and clutch assembly. Refer to Power Sliding Door Motor Clutch Replacement .

Is the repair complete?

Go to Step 7

--

6

Replace the rear side door actuator control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Is the repair complete?

Go to Step 7

--

7

Re-initialize the power sliding door and operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2