Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System
- Remove the floor console. Refer to Front Floor Console Replacement .
- Remove the connector position assurance lock, which is tethered to the SDM connector.
- Disconnect the SDM electrical connector.
- Remove the SDM mounting bolts and discard them.
Caution: Be careful when you handle a sensing and diagnostic module (SDM). Do not strike
or jolt the SDM. Before applying power to the SDM:
• Remove any dirt, grease, etc. From the mounting surface. • Position the SDM horizontally on the mounting surface. • Tighten all of the SDM fasteners and SDM bracket fasteners to the specified
torque value.
Important: If the vehicle interior has been exposed to extensive water intrusion such as water leaks, driving through high water, flooding, or other causes, the sensing and diagnostic module (SDM) and SDM connector may need to be replaced. With the ignition OFF, inspect the area around the SDM, including the carpet. If any significant soaking or evidence of previous soaking is detected, the water must be removed, the water damage repaired, and the SDM and SDM connector must be replaced. Before attempting any of these repairs, the supplemental restraint system (SIR) must be disabled. Refer to Disabling the SIR System .
Installation Procedure
- Install the SDM.
- Install the new SDM mounting bolts.
- Connect the SDM electrical connector.
- Install the connector position assurance lock, which is tethered to the SDM connector.
- Install the floor console. Refer to Front Floor Console Replacement .
- Enable the SIR system.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the SDM Mounting Bolts to 10 N·m
(89 lb in).
