1. Raise the front of the vehicle to allow the front suspension to hang free. Refer to Lifting and Jacking the Vehicle .
2. Grasp the tire at the top and the bottom.
3. Move the top of the tire in an in-and-out motion.
4. Look for any horizontal movement of the knuckle relative to the control arm.
5. Ball joints must be replaced under the following conditions:

•	The joint is loose.

•	The ball seal is cut.

•	The ball stud is disconnected from the knuckle.

•	The ball stud is loose at the knuckle.

•	The ball stud can be twisted in its socket with finger pressure.

Make sure to inspect the tightness of the ball stud in the knuckle boss during each inspection of the ball joint. One way to inspect the ball stud for wear is to shake the wheel and feel for movement of the stud end at the knuckle boss.

Another way to inspect the ball stud for wear is to inspect the fastener torque at the pinch nut. A loose nut can indicate a stressed stud or a hole in the knuckle boss.

Worn or damaged ball joints and knuckles must be replaced.