Notice: When replacing the door lock striker, only use the manufactures replacement part. Do not use a replacement part of a lesser quality or a substitute design. The use of a lesser quality part could lead to an improperly operating door retention system.

The door lock striker consists of a striker with 2 screws that are threaded into a tapped, floating cage plate located in the appropriate body pillar. This floating cage plate allows the striker to be easily adjusted in or out and up or down. The door is secured in the closed position when the door lock fork snaps over and engages the striker.

An adjustment of the striker in the up and down or in and out directions may be necessary for a number of reasons:

In order to adjust the door striker in an up and down or in and out direction, perform the following procedure

1. The door must be properly aligned.
2. Loosen the striker screws.
3. The floating cage plate can be moved slightly using the ends of the striker screws. Move the floating cage plate to the desired position.

Notice: In order to oblong the striker mounting hole to assist in further striker adjustment, use a die grinder with a flat-headed grinding bit. This type of bit will help to prevent damage to the tapered floating cage plate. The striker and the tapped floating cage plate are important attaching parts that could affect operation of the door closing and latching systems.

4. If proper adjustment requires that the floating cage plate be moved more than is possible, use an electric hand drill and a 3/8 inch rotary file with a flat head in order to enlarge the body opening in the direction required.

Notice: Refer to Fastener Notice in the Preface section.

5. Tighten the striker screws to the correct position.

Tighten
Tighten the striker screws to 24 N·m (18 lb ft).