Tools Required

DT 46473 (DW260-050) Park/Neutral Position Switch Installer

Caution: Refer to Battery Disconnect Caution in the Preface section.




1. Disconnect the negative battery cable.
2. Disconnect the park/neutral position switch electrical connector.
3. Disconnect the shift control cable and the retaining clip



4. Remove the shift lever nut and the shift lever.



5. Remove the park/neutral start switch.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the park/neutral start switch.

Tighten
Tighten the bolts to 10 N·m (89 lb in).

Important: When installing the park/neutral switch, use the special service tools. Position the shift lever in NEUTRAL.

2. Use the DT 46473  (1) to adjust the park/neutral switch.



3. Install the shift lever and the shift lever nut.

Tighten
Tighten the nut to 10 N·m (89 lb in).




4. Connect the shift control cable and the retaining clip.
5. Connect the park/neutral position switch electrical connector.
6. Connect the negative battery cable.