GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1279920  Size: SH
  1. Disconnect the negative battery cable.
  2. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  3. Remove the 2 bolts and the nut on the right headlamp.
  4. Remove the headlamp.

  5. Object Number: 1279951  Size: SH
  6. Remove the 2 nuts on the high pressure pipes flange from the top of the receiver-drier.
  7. Remove the O-ring and discard it.
  8. Loosen the bolt securing the receiver-drier band clamp.
  9. Remove the receiver-drier.
  10. Cap the open connections to prevent contamination.
  11. Drain the oil from the receiver-drier into a container. Measure the amount of oil drained from the receiver-drier. Discard the used oil.

Installation Procedure


    Object Number: 1279951  Size: SH

    Important: Do not uncap the new unit until just prior to installation.

  1. Add oil to the compressor. Use the exact amount of oil that was drained from the receiver-drier.
  2. Install the receiver-drier.
  3. Tighten the bolt securing the receiver-drier band clamp.
  4. Install new O-rings to the high pressure pipes.
  5. Install the high pressure pipes to the top of the receiver-drier.
  6. Notice: Refer to Fastener Notice in the Preface section.

  7. Install the 2 nuts to the flange of the pressure pipes.
  8. Tighten
    Tighten the flange nuts to 14 N·m (10 lb ft).


    Object Number: 1279920  Size: SH
  9. Install the headlamp.
  10. Install the 2 bolts and the nut to the headlamp.
  11. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  12. Connect the negative battery cable.