For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0201 00: Antilock Brake System (ABS) Enable Relay Contact CircuitCircuit/System Description
The EBCM controls it's internal valve relay to command the valve solenoids ON or OFF.
Conditions for Running the DTC
| • | Ignition voltage is greater than 10 volts. |
| • | The solenoid relay is commanded ON. |
Conditions for Setting the DTC
| • | The EBCM detects no change when commanding the valve relay ON or OFF. |
| • | The EBCM detects a stuck open solenoid valve relay or an open circuit between the solenoid valve relay and solenoid valves. |
Action Taken When the DTC Sets
| • | The EBCM disables the antilock brake system (ABS)/traction control system (TCS). |
| • | A DIC message and/or a warning indicator may be displayed. |
Conditions for Clearing the DTC
| • | The condition for setting the DTC is no longer present. |
| • | The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Antilock Brake System Connector End Views
Description and Operation
Electrical Information Reference
Scan Tool Reference
Circuit/System Verification
Ignition ON, verify that DTC C0201 is not set.
| ⇒ | If DTC is set, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup, and programming
