Preliminary Procedure

Open both side doors in order to remove the rocker panel front molding assembly.

1

Rocker Panel Finish Panel Screw (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Procedure

1. Remove the rocker panel rear molding assembly.
2. Remove the 3 front finish panel screws.
3. Release the 6 lower rocker molding retainers.
4. Release the 12 upper rocker molding retainers.

Tighten
1.5 N·m (13 lb in)

2

Rocker Panel Rear Molding Retainer (Qty: 18)

3

Rocker Panel Front Molding Assembly

Tip
Replace the retainer clips as needed.