Fluid Leak at Transfer Case Weep Hole (Replace Front Wheel Drive Intermediate (Inner) Shaft Seal)
| Subject: | Fluid Leak at Transfer Case Weep Hole (Replace Front Wheel Drive Intermediate (Inner) Shaft Seal) |
| Models: | 2008 Buick Enclave |
| 2008 Chevrolet Equinox Sport |
| 2007-2008 GMC Acadia |
| 2008 Pontiac Torrent GXP |
| 2007-2008 Suzuki XL-7 |
| with 6T70/75 AWD/PTU Automatic Transmission (RPO MH4 or MH6) for GM or AF33-5 AWD/PTU Automatic Transmission (RPO M45) for Suzuki and Getrag 760/790 Transfer Case |
Condition
Some customers may comment on a fluid leak from the transmission or transfer case area. Technicians may find that the fluid is leaking from the transfer case/PTU weep hole farthest from the transmission, near the passenger side.
Cause
The front wheel drive intermediate (inner) shaft seal may be leaking. Due to low ambient temperatures with various runout conditions between the intermediate drive shaft and the input shaft, the seal material may not properly seal fluid.
Correction
Replace the front wheel drive intermediate (inner) shaft seal with a new designed seal.
Important: Selecting the correct replacement seal is critical due to a 2008 mid-model design update. Use the information below to determine which seal to use. For additional information, refer to New Product Information in the Getrag 760/790 Transfer Case category in SI.
For Acadia and Enclave
| • | For vehicles built prior to VIN Breakpoint 8J217964, use first design seal, P/N 19180998 (Green). |
| • | For vehicles built on or after VIN Breakpoint 8J217964, use second design seal, P/N 19206322 (Green). |
For Equinox and Torrent
| • | For vehicles built prior to VIN Breakpoint 86075818, use first design seal, P/N 19180998 (Green). |
| • | For vehicles built on or after VIN Breakpoint 86075818, use second design seal, P/N 19206322 (Green). |
For Suzuki XL-7
| • | For vehicles built prior to VIN Breakpoint 86115983, use first design seal, P/N 19180998 (Green). |
| • | For vehicles built on or after VIN Breakpoint 86115983, use second design seal, P/N 19206322 (Green). |
Notice: Second design seals are not compatible with first design transfer cases. Installing a second design seal in a first design transfer case will create a transmission fluid leak due to interference with the input shaft.
Seal Installation
Installing the replacement seal to the proper depth is critical. Use the DT-48078 - Inner Drive Shaft Seal installer with a J 8092 - Driver Handle to install the seal 2.8 mm (0.11 in) (a) from the end of the input shaft. Refer to the Front Drive Axle Inner Shaft Seal Replacement procedure in SI.
Parts Information
Part Number | Description |
|---|---|
19180998 (First Design - Pre Breakpoint) | Seal, Front Wheel Drive Intermediate (Inner) Shaft |
19206322 (Second Design - Post Breakpoint) | Seal, Front Wheel Drive Intermediate (Inner) Shaft |
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation | Description | Labor Time |
|---|---|---|
K9803* (Acadia, Enclave) | Replace Front Wheel Drive Intermediate (Inner) Shaft Seal | 3.5 hrs |
K9803* (Equinox, Torrent, Suzuki) | Replace Front Wheel Drive Intermediate (Inner) Shaft Seal | 4.7 hrs |
* This labor operation number is for bulletin use only. This number will not be published in the Labor Time Guide. | ||
