Starter Switch Check
Caution: When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.
- Before you start, be sure you have enough room around the vehicle.
- Firmly apply both the parking brake and the regular brake. See Parking Brake .
- Try to start the engine in each gear. The vehicle should start only in PARK (P) or NEUTRAL (N). If the vehicle starts in any other position, contact your dealer/retailer for service.
Do not use the accelerator pedal, and be ready to turn off the engine immediately if it starts.
Automatic Transmission Shift Lock Control System Check
Caution: When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.
- Before you start, be sure you have enough room around the vehicle. It should be parked on a level surface.
- Firmly apply the parking brake. See Parking Brake .
- With the engine off, turn the ignition to ON/RUN, but do not start the engine. Without applying the regular brake, try to move the shift lever out of PARK (P) with normal effort. If the shift lever moves out of PARK (P), contact your dealer/retailer for service.
Be ready to apply the regular brake immediately if the vehicle begins to move.
Ignition Transmission Lock Check
While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position.
| • | The ignition should turn to LOCK/OFF only when the shift lever is in PARK (P). |
| • | The ignition key should come out only in LOCK/OFF. |
Contact your dealer/retailer if service is required.
Parking Brake and Automatic Transmission Park (P) Mechanism Check
Caution: When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.
Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.
| • | To check the parking brake's holding ability: With the engine running and the transmission in NEUTRAL (N), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only. |
| • | To check the PARK (P) mechanism's holding ability: With the engine running, shift to PARK (P). Then release the parking brake followed by the regular brake. |
Contact your dealer/retailer if service is required.
Underbody Flushing Service
At least every spring, use plain water to flush any corrosive materials from the underbody. Take care to clean thoroughly any areas where mud and other debris can collect.
