GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2006 🢒 Canyon Pickup - 2WD 🢒 Body 🢒 Collision Repair 🢒 Front Inner Hinge Pillar Reinforcement Sectioning

Removal Procedure
  1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  3. Remove all related panels and components.
  4. Repair as much of the damage as possible to factory specifications. Refer to Dimensions - Body .
  5. Note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.
  6. Remove the front outer hinge pillar. Refer to Front Hinge Pillar Sectioning .

    7. Object Number: 1366209 Size: SH
  7. On the original reinforcement panel, measure 50 mm (2 in) down from the body line and mark a horizontal line (a).
  8. Cut the inner reinforcement along this line.
  9. Locate, mark, and drill out all factory welds, as necessary. Note the number and location of welds for installation of the service part.
  10. Remove the damaged section of the inner reinforcement.

Installation Procedure

    Object Number: 314551 Size: SH
  1. Cut and remove 30 mm (1 3/16 in) from the flanges on either side of the remaining section of the original hinge pillar to create a 30-mm (1 3/16-in) flange.
  2. Cut 5-mm (3/16-in) wide gaps in the bottom corners.

    3. Object Number: 314596 Size: SH
  3. Step the tabs inward to allow the door frame inner reinforcement service section to fit over the original inner reinforcement.
  4. Weld the tabs together along the edges (1).

    5. Object Number: 1366209 Size: SH
  5. On the service part measure 20 mm (1 in) down from the body line and mark a horizontal line (a).
  6. Cut the hinge pillar reinforcement along this line.

    7. Object Number: 1366210 Size: SH
  7. Drill 8-mm (5/16-in) plug weld holes as necessary in the locations noted from the original panel.
  8. Drill plug weld holes along the sectioning cut of the service part. These holes should be located approximately 15 mm (9/16 in) from the edge of the cut.
  9. Prepare mating surfaces and position the service section over the stepped tab on the original inner reinforcement allowing 30 mm (1 3/16 in) of overlap.
  10. Plug weld accordingly.

    11. Object Number: 314556 Size: SH
  11. Stitch weld along the entire joint with 25 mm (1 in) gaps between the welds (1).
  12. Go back and complete the stitch weld. This will create a solid joint with minimal heat distortion.
  13. Install the front outer hinge panel. Refer to Front Hinge Pillar Sectioning .
  14. Clean and prepare all welded surfaces.
  15. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.
  16. Paint the repair area. Refer to Basecoat/Clearcoat Paint Systems in Paint and Coatings.
  17. Install all related panels and components.
  18. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  19. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.