GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2007 🢒 Canyon Pickup - 2WD 🢒 Engine 🢒 Engine Cooling 🢒 Engine Oil and Oil Filter Replacement

Removal Procedure

    Object Number: 953916 Size: SH
  1. Remove the oil fill cap.
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Clean any dirt and/or debris away from the oil pan drain plug area.
  4. Position a suitable drain pan under the oil pan drain plug.
  5. Remove the oil pan drain plug.
  6. Allow the oil to drain completely.
  7. Clean and inspect the oil pan drain plug, replace if necessary.
  8. Clean and inspect the oil pan drain plug sealing surface, replace the oil pan if necessary.
  9. Wipe any remaining oil from the drain plug hole and reinstall the oil pan drain plug until snug.
  10. Position the container under the engine oil filter drain deflector.

    11. Object Number: 1243906 Size: SH
  11. Position a suitable drain pan under the oil filter.
  12. Remove the oil filter.
  13. Ensure that the oil filter gasket is still on the old oil filter, if not remove the oil filter gasket from the adapter.

Installation Procedure

    Object Number: 1243906 Size: SH
  1. Apply clean engine oil to the NEW oil filter gasket.

    2. Notice: Refer to Component Fastener Tightening Notice in the Preface section.

  2. Install the NEW oil filter.

    3. Tighten
    Tighten the oil filter to 10 N·m (89 lb in), plus an additional 150 degrees.

  3. Wipe any excess oil from the oil filter drain deflector.

    4. Object Number: 953916 Size: SH
  4. Tighten the oil pan drain plug.

    5. Tighten
    Tighten the drain plug to 26 N·m (19 lb ft).

  5. Remove the oil drain pan from under the vehicle.
  6. Lower the vehicle.
  7. Fill the engine with new engine oil. Refer to Fluid and Lubricant Recommendations and Approximate Fluid Capacities .
  8. Start the engine.
  9. Inspect for oil leaks after engine start up.
  10. Turn off the engine and allow the oil a few minutes to drain back into the oil pan.
  11. Remove the oil level indicator from the oil indicator tube.
  12. Clean off the indicator end of the oil level indicator with a clean paper towel or cloth.
  13. Install the oil level indicator into the oil level indicator tube until the oil level indicator handle contacts the top of the oil level indicator tube.
  14. Again, remove the oil level indicator from the oil level indicator tube keeping the tip of the oil level indicator down.
  15. Check the level of the engine oil on the oil level indicator.
  16. If necessary, adjust the oil level by adding or draining oil.
  17. Check for oil leaks.
  18. Install the oil fill cap.