Schematic Reference: Moveable Window Schematics

Connector End View Reference: Window Systems Connector End Views

Did you review the Power Windows Description and Operation?

Go to Step 2

Go to Symptoms - Fixed and Moveable Windows

Verify that all the power windows are inoperative.

Do the power windows operate normally?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Turn OFF the ignition.
2. Disconnect the driver window switch.
3. Turn ON the ignition, with the engine OFF.
4. Probe the accessory voltage circuit of the driver window switch harness connector with a test lamp that is connected to a good ground.

Does the test lamp illuminate?

Go to Step 4

Go to Step 5

Connect a test lamp between the accessory voltage circuit of the driver window switch harness connector and the ground circuit of the driver window switch harness connector.

Does the test lamp illuminate?

Go to Step 7

Go to Step 8

Test the power window master switch lockout signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 10

Go to Step 6

Test the accessory voltage circuit of the driver window switch for a short to ground or an open. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 10

Go to Symptoms - Wiring Systems

Inspect for poor connections at the harness connector of the driver window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 10

Go to Step 9

Repair the open in the ground circuit. Refer to Wiring Repairs .

Did you complete the repair?

Go to Step 10

--

Replace the driver window switch. Refer to Entertainment/Communication Component Views .

Did you complete the replacement?

Go to Step 10

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2