GM Service Manual Online
For 1990-2009 cars only

Test Description

The number below refers to the step number on the diagnostic table.

  1. This action will disable the HVAC control module output to evaporator temperature sensor.

Step

Action

Yes

No

Schematic Reference: HVAC Schematics

Connector End View Reference: HVAC Connector End Views

DEFINITION: The A/C compressor clutch will not disengage when an A/C request has not been made and a Powertrain DTC has not been set.

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Start the engine.
  2. Place the blower motor switch in the OFF position.

Is the A/C compressor clutch engaged?

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections

3

With a scan tool, observe the A/C Request Signal parameter in the Body Control Module Input data list.

Does the scan tool indicate the A/C Request Signal parameter is Yes?

Go to Step 5

Go to Step 4

4

Disconnect the A/C compressor clutch relay.

Does the A/C compressor clutch disengage?

Go to Step 9

Go to Step 6

5

Disconnect the evaporator temperature sensor.

Does the A/C compressor clutch disengage?

Go to Step 7

Go to Step 8

6

Test the supply voltage circuit of the A/C compressor clutch for a short to voltage. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 17

Go to Step 10

7

Test the A/C request signal circuit of the HVAC control module for a short to voltage. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 17

Go to Step 11

8

Test the A/C request signal circuit of the body control module (BCM) for a short to voltage. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 17

Go to Step 12

9

Inspect for poor connections at the A/C compressor clutch relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 17

Go to Step 13

10

Inspect for poor connections at the harness connector of the A/C compressor clutch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 17

Go to Step 14

11

Inspect for poor connections at the harness connector of the HVAC control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 17

Go to Step 15

12

Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 17

Go to Step 16

13

Replace the A/C compressor clutch relay. Refer to Compressor Relay Replacement .

Did you complete the replacement?

Go to Step 17

--

14

Replace the A/C compressor. Refer to Air Conditioning Compressor Replacement .

Did you complete the replacement?

Go to Step 17

--

15

Replace the HVAC control module. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 17

--

16

Replace the BCM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 17

--

17

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3