GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
GMC_Truck
🢒
2009
🢒
Canyon Pickup - 2WD
🢒
Engine
🢒
Engine Controls and Fuel - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L
🢒 Fuel Tank Filler Pipe Replacement
Removal Procedure
Partially drain the fuel tank below the level of the fuel fill tube. Refer to
Fuel Tank Draining
.
Raise and support the vehicle, high enough to access the fuel fill hose through the wheelhouse liner. Refer to
Lifting and Jacking the Vehicle
.
Remove the left rear pickup box wheelhouse liner. Refer to
Pickup Box Wheelhouse Liner Replacement
.
Remove the fuel fill hose ground strap bolt.
Remove the ground strap from the frame.
Loosen the fuel fill hose clamp (2) at the fuel tank.
Disconnect the evaporative emission (EVAP) line (1) quick connect fitting from the fill tube vent line. Refer to
Plastic Collar Quick Connect Fitting Service
.
Separate the fuel fill hose from the fuel tank.
Remove the fuel fill hose screws.
Remove the fuel fill hose from the vehicle.
Cap the open end of the fuel tank in order to prevent system contamination.
Installation Procedure
Uncap the fuel tank.
Position the fuel fill hose to the fender.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the fuel fill hose screws and tighten to
2 N·m (18 lb in)
.
Install the fuel fill hose to the fuel tank.
Connect the fuel tank EVAP line (1) quick connect fitting to the fill tube vent line. Refer to
Plastic Collar Quick Connect Fitting Service
.
Tighten the fuel fill hose clamp (2) at the fuel tank to
2.5 N·m (22 lb in)
.
Install the ground strap to the frame. Ensure that the anti rotation tab is inserted into the hole in the frame.
Install the fuel fill hose ground strap bolt and tighten to
9 N·m (80 lb in)
.
Install the left rear pickup box wheelhouse liner. Refer to
Pickup Box Wheelhouse Liner Replacement
.
Lower the vehicle.
Refill the fuel tank.
Install the fuel fill cap.