GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2009 🢒 Canyon Pickup - 2WD 🢒 Suspension 🢒 Tires and Wheels 🢒 Wheel Drive Shaft Replacement

Removal Procedure

    Object Number: 1253298 Size: SH
  1. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation

    2. Object Number: 1339817 Size: SH

    Note: DO NOT reuse the wheel drive shaft nut, replace with new.

  2. Remove the wheel drive shaft nut and washer.

    3. Object Number: 1135803 Size: SH
  3. Remove the steering knuckle assembly. Refer to Steering Knuckle Replacement.

    4. Object Number: 751412 Size: SH
  4. Release the wheel drive shaft by placing a brass drift against the tripod housing. Firmly strike the brass drift with a hammer to release the drive shaft. Left side shown, right side similar.

    5. Object Number: 1339815 Size: SH
  5. Remove the front wheel drive shaft from the vehicle.

Installation Procedure

    Object Number: 1339815 Size: SH

    Note: When installing the front wheel drive shaft, a snap or pop should be heard and felt when the front wheel drive shaft is properly seated in the differential case.

  1. Install the front wheel drive shaft in the front differential.

    2. Object Number: 1135803 Size: SH
  2. Install the steering knuckle assembly. Refer to Steering Knuckle Replacement.

    3. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1339817 Size: SH
  3. Install the new front wheel drive shaft nut and washer and tighten the nut to 260 N·m (191 lb ft).
  4. Check the fluid level of the front differential. Add fluid if necessary. Refer to Front Axle Lubricant Replacement.

    5. Object Number: 1253298 Size: SH
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  6. Lower the vehicle.