GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2009 🢒 Canyon Pickup - 2WD 🢒 Transmission 🢒 Manual Transmission - Aisin AR5 🢒 Input Shaft Bearing Retainer Replacement

Removal Procedure
  1. Drain the transmission fluid. Refer to Transmission Fluid Replacement.
  2. Remove the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement.

    3. Object Number: 872978 Size: SH
  3. Remove the input shaft bearing retainer bolts.

    4. Discard the bolts.

  4. Remove the input shaft bearing retainer.
  5. Clean and inspect the input shaft bearing retainer. Refer to Transmission Case Cleaning and Inspection.

Installation Procedure

    Object Number: 881220 Size: SH
  1. Apply a 3 mm (1/8 in) bead of sealant GM P/N 89020326 (Canadian P/N 89021188) to the input shaft bearing retainer.

    2. Object Number: 872978 Size: SH

    Note: Ensure the seal does not catch on the input shaft splines.

  2. Position the input shaft bearing retainer to the transmission.
  3. Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads of the input shaft bearing retainer bolts if new bolts are not available.

    4. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the NEW input shaft bearing retainer bolts.

    5. Tighten
    Tighten the input shaft bearing retainer bolts to 17 N·m (13 lb ft).

  5. Install the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement.
  6. Fill the transmission fluid. Refer to Transmission Fluid Replacement.