Removal Procedure
- Disconnect the electrical connector from the mass air flow (MAF)/intake air temperature
(IAT) sensor.
- Loosen the clamp and disconnect the air cleaner outlet duct from the air cleaner assembly.
- Remove the 2 bolts (3) and nut (5) securing the air cleaner assembly to the wheel house (4).
- Remove the air cleaner assembly from the vehicle.
Installation Procedure
- Position the air cleaner assembly into the engine compartment, inserting the snorkel (2) into the fender (1).
Notice: Refer to Fastener Notice in the Preface section.
- Install the 2 bolts (3) and nut (5) securing the air cleaner assembly to the wheel house (4).
Tighten
• | Tighten the air cleaner assembly bolts to 15 N·m (11 lb ft). |
• | Tighten the air cleaner assembly nut to 15 N·m (11 lb ft). |
- Connect the air cleaner outlet duct to the air cleaner assembly.
Tighten
Tighten the air cleaner outlet duct clamp to 6 N·m (53 lb in).
- Connect the engine wiring harness electrical connector to the MAF/IAT sensor.