Removal Procedure
- Remove the intake manifold. Refer to
Intake Manifold Replacement
in Engine Mechanical - 2.8L (LK5) or
Intake Manifold Replacement
in Engine Mechanical -
3.5L (L52).
- Remove the starter solenoid S terminal nut (3)
and disconnect the lead (4) from the starter.
- Remove the starter terminal nut (1) and disconnect the battery
positive cable (2) from the starter.
- Remove
the starter motor mounting nut (1) and bolt (4).
- Remove the starter motor (3) from the engine.
Installation Procedure
- Position
the starter motor (3) over the stud (2).
Notice: Refer to Fastener Notice in the Preface section.
- Install the starter motor mounting nut (1) and bolt (4).
Tighten
Tighten the starter motor mounting fasteners to 50 N·m (37 lb ft).
- Connect the battery positive cable (2)
to the starter and install the starter terminal nut (1)
Tighten
Tighten the battery positive cable to starter terminal nut to 9 N·m
(80 lb in).
- Connect the lead (4) to the starter solenoid and install the starter
solenoid S terminal nut (3).
Tighten
Tighten the starter solenoid S terminal nut to 3.5 N·m (31 lb in).
- Install the intake manifold. Refer to
Intake Manifold Replacement
in Engine Mechanical - 2.8L (LK5) or
Intake Manifold Replacement
in Engine Mechanical -
3.5L (L52).