Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the nuts from the link assemblies.
- Remove the link assemblies.
- Remove the insulator clamp bolts.
- Remove the clamps.
- Remove the stabilizer shaft.
- Remove the insulators.
- Inspect all of the parts for wear and damage.
Installation Procedure
- Install the insulators to the stabilizer shaft .
- Install the stabilizer shaft .
- Install the clamps over the insulators and the stabilizer shaft.
Notice: Refer to Fastener Notice in the Preface section.
- Install insulator clamp bolts.
Tighten
Tighten the bolts to 50 N·m (37 lb ft).
- Support the lower control arms at curb height.
- Install the link assemblies.
- Install the nuts to the link assemblies.
Tighten
Tighten the nut to 44 N·m (32 lb ft).
- Lower the vehicle.