GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Important: The vehicle communication interface module (VCIM) has a specific set of unique numbers that tie the module to each vehicle. These numbers, the 10-digit station identification (STID)and the 11-digit electronic serial number (ESN), are used by the National Cellular Network and OnStar® to identify the specific vehicle. Because these numbers are tied to the vehicle identification number of the vehicle, you must never exchange these parts with those of another vehicle.

  1. Position the right rear seat bottom to a cargo position.
  2. Ensure the ignition switch is in the OFF position.

  3. Object Number: 1251728  Size: SH
  4. Remove the service panel located on the right side of the instrument panel (I/P).

  5. Object Number: 1365493  Size: SH
  6. Disconnect the VCIM electrical connectors as necessary.

  7. Object Number: 1365496  Size: SH
  8. Remove the screw retaining the VCIM to the bracket.

  9. Object Number: 1367811  Size: SH
  10. Release the tab (1) on the bracket.

  11. Object Number: 1367812  Size: SH
  12. Remove the VCIM from the bracket.

  13. Object Number: 1367814  Size: SH
  14. Remove the VCIM from the vehicle.

Installation Procedure

  1. If replacing the VCIM, record the 10-digit STID number, and the 11-digit ESN number from the labels on the new module.
  2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1367811  Size: SH
  3. Install the VCIM to the bracket ensuring the retaining tab (1) is fully seated.
  4. Tighten
    Tighten the screw fully driven , seated and not stripped.


    Object Number: 1365493  Size: SH
  5. Connect the VCIM electrical connectors as necessary.

  6. Object Number: 1251728  Size: SH
  7. Install the service panel.
  8. Important: After replacing the VCIM, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of the OnStar® system. This action will cause a DTC to set.

  9. Reconfigure the OnStar® system. Refer to OnStar Reconfiguration .