Circuit Description
The Crankshaft Position (CKP) system variation learn feature is used to calculate reference period errors caused by slight tolerance variations in the crankshaft, and the crankshaft position sensors. The calculated error allows the powertrain control module (PCM) to accurately compensate for reference period variations. This enhances the ability of the PCM to detect misfire events over a wider range of engine speed and load. The PCM stores the crankshaft position system variation values after a learn procedure has been performed. If the actual crankshaft position variation is not within the crankshaft position system variation compensating values stored in the PCM, DTC P0300 may set. If the PCM detects the CKP system variation values are not stored in the PCM memory, DTC P0315 sets.
Conditions for Running the DTC
| • | DTCs P0013, P0014, P0335, P0336, P0340, P0341 are not set. |
| • | The engine coolant temperature is more than 70°C (158°F). |
Conditions for Setting the DTC
The crankshaft position system variation values are not stored in the PCM memory.
Action Taken When the DTC Sets
| • | The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails. |
| • | The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame/Failure Records. |
Conditions for Clearing the MIL/DTC
| • | The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail. |
| • | A current DTC, Last Test Failed, clears when the diagnostic runs and passes. |
| • | A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic. |
| • | Clear the MIL and the DTC with a scan tool. |
Step | Action | Yes | No | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
1 | Did you perform the Diagnostic System Check-Engine Controls? | Go to Step 2 | |||||||||||||||
2 | Perform the Crankshaft Position (CKP) system variation learn procedure. Refer to Crankshaft Position System Variation Learn . Does the scan tool display Learned this Ignition? | Go to Step 4 | Go to Step 3 | ||||||||||||||
3 | If the Crankshaft Position system variation learn procedure cannot be performed successfully, check for the following conditions:
Did you find and correct the condition? | Go to Step 4 | -- | ||||||||||||||
4 |
Did the DTC fail this ignition? | Go to Step 2 | Go to Step 5 | ||||||||||||||
5 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? | System OK |
