Tools Required

J 44221 Camshaft Holding Tool

1. Remove the camshaft cover. Refer to Camshaft Cover Replacement .
2. Remove the engine front cover. Refer to Engine Front Cover Replacement .
3. Rotate the crankshaft in the engine rotational direction clockwise, until the #1 piston is at top dead center (TDC) on the compression stroke.

Caution: Refer to Camshaft Holding Tool Caution in the Preface section.




4. Install the J 44221 to the rear of the camshafts.



5. Using the timing marks on the following as a reference, make a mark on the timing chain links (1) adjacent to them:

•	The exhaust camshaft position actuator sprocket

•	The intake camshaft sprocket

•	The crankshaft sprocket




6. Release the tension on the timing chain by moving the tensioner shoe in.



7. Place the tee into the tensioner to hold the shoe in place.



8. Remove the cylinder head access hole plug.



9. Remove the timing chain tensioner shoe bolt.
10. Remove the timing chain tensioner shoe from the engine.

1. Position the timing chain tensioner shoe to the engine.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the timing chain tensioner shoe bolt.

Tighten
Tighten the bolt to 25 N·m (18 lb ft).




3. Install the cylinder head access hole plug.

Tighten
Tighten the plug to 5 N·m (44 lb in).




4. Remove the tee in the timing chain tensioner in order to regain tension on the timing chain.



5. Remove the J 44221 from the camshafts.




Important: Every 7th link of the timing chain is darkened to aid in aligning the timing marks.

6. Align the marked links (1) of the timing chain with the timing marks on the following:

•	The exhaust camshaft position actuator sprocket

•	The intake camshaft sprocket

•	The crankshaft sprocket

7. Install the engine front cover. Refer to Engine Front Cover Replacement .
8. Install the camshaft cover. Refer to Camshaft Cover Replacement .