Removal Procedure
- Disconnect the engine wiring harness electrical connector (4) from the
camshaft position (CMP) sensor (5).
- Remove the CMP sensor retaining bolt.
- Remove the CMP sensor from the cylinder head.
Discard the O-ring seal.
Installation Procedure
- Install a new O-ring seal to the CMP sensor.
- Lightly lubricate the O-ring seal with clean engine oil.
- Install the CMP sensor into the cylinder head.
Notice: Refer to Fastener Notice in the Preface section.
- Install the CMP sensor bolt.
Tighten
Tighten the camshaft position (CMP) sensor bolt to 10 N·m (89 lb in).
- Connect the engine wiring harness electrical connector (4) to the CMP sensor (5).