Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Disconnect the wiring harness electrical connector from the vehicle speed sensor.
- Remove the harness connector.
- Remove the bolt (2).
- Remove the vehicle speed sensor (1).
- Remove the O-ring seal (3).
Installation Procedure
- Install the O-ring seal (3) on the vehicle speed sensor (1).
- Coat the O-ring seal (3) with a thin film of transmission fluid.
- Install the vehicle speed sensor (1) into the transmission case.
Notice: Refer to Fastener Notice in the Preface section.
- Install the bolt (2).
Tighten
Tighten the bolt to 11 N·m (97 lb in).
- Connect the wiring harness electrical connector to the vehicle speed sensor.
- Lower the vehicle.
- Refill the fluid as required.