GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2006 🢒 Canyon Pickup - 4WD 🢒 Body 🢒 Collision Repair 🢒 Windshield Frame Header Front Panel Replacement

Removal Procedure

    Caution: Refer to Approved Equipment for Collision Repair Caution in the Preface section.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.

    3. Object Number: 1359522 Size: SH
  3. Remove all related panels and components.
  4. Repair as much of the damage as possible to factory specifications. Refer to Dimensions - Body .
  5. Note the location and remove the sealers and anticorrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.

    6. Object Number: 1284458 Size: SH
  6. Remove the roof panel. Refer to Roof Outer Panel Replacement .
  7. Note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.

    8. Object Number: 1359524 Size: SH

    Important: Do not damage any inner panels or reinforcements.

  8. Locate and drill out all factory welds. Note the number and location of welds for installation of the service part.

    9. Object Number: 1359527 Size: SH
  9. Remove the damaged windshield header panel.

Installation Procedure

    Object Number: 1359528 Size: SH

    Important: If the location of the original plug weld holes can not be determined, or if structural weld-thru adhesive is present, space the plug weld holes every 40 mm (1½ in) apart.

  1. Drill 8 mm (5/16 in) plug weld holes in the service part as necessary in the locations noted from the original panel.
  2. Prepare all mating surfaces as necessary.
  3. Apply 3M® Weld-Thru coating P/N 05916 or equivalent to all mating surfaces

    4. Object Number: 1359530 Size: SH
  4. Position the windshield header panel.

    5. Object Number: 1359531 Size: SH
  5. Align the roof header panel over the locator tabs (1).

    6. Object Number: 1359532 Size: SH
  6. Plug weld accordingly.

    7. Object Number: 1284462 Size: SH
  7. Install the roof panel. Refer to Roof Outer Panel Replacement .
  8. Clean and prepare all welded surfaces.
  9. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.
  10. Paint and repair the area. Refer to Basecoat/Clearcoat Paint Systems in Paint and Coatings.
  11. Install all related panels and components.
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  13. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.