GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2006 🢒 Canyon Pickup - 4WD 🢒 Body 🢒 Instrument Panel, Gages, and Console 🢒 Headlamp Switch Replacement

Removal Procedure
  1. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement in Instrument Panel, Gages and Console.

    2. Object Number: 1326608 Size: SH
  2. Remove the screw retaining the switch to the instrument panel (I/P).
  3. Partially remove the switch from the I/P.
  4. Disconnect the switch electrical connector.
  5. Remove the switch from the vehicle.

Installation Procedure

    Object Number: 1326608 Size: SH
  1. Position the switch to the I/P.
  2. Connect the electrical connector to the switch.
  3. Install the switch to the I/P.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the screw retaining the switch to the I/P.

    5. Tighten
    Tighten the screw to 2.5 N·m (22 lb in).

  5. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement in Instrument Panel, Gages and Console.